The problem of water leakage in the bathroom, depending on the location, our response is not the same.

First, the waterproof layer leaks

If the waterproof layer leaks, all the original tiles need to be removed first, and the base layer should be cleaned. After the cement and mortar are properly proportioned, the waterproofing is further processed. Generally speaking, the wall surface height of the water-repellent treatment is about 30 cm, and such a treatment can more effectively prevent the occurrence of water leakage.

Second, the bathroom waterproof layer leaks

If there is a leak in the waterproof layer of the bathroom, it is relatively simple to handle. At this time, it is not necessary to remove the tile, and it is only necessary to use a permeable waterproofing agent to make another waterproofing on the surface of the bathroom. This allows the water to flow underground and flow directly from the waterway.

Third, the upper and lower water pipes leak

The leakage of water from the upper and lower pipes is complicated. If the water pipes are underground, we also need to plan the bricks, but it does not mean that the entire bathroom should be renovated. If there is a problem with the inlet pipe, we can change it to a clear pipe and the leaking pipe is discarded. If the water is leaking from the downpipe, the most important thing is to confirm the location of the leak, and then partially plan the brick according to the situation, instead of all the planing.

Fourth, the ceiling waterproof

The bathroom is a relatively humid environment in the home, and it is a common occurrence to be surrounded by water vapor. Therefore, regarding the leakage maintenance of the bathroom, we can completely consider the use of pvc gussets with better waterproof performance. By enhancing the moisture-proof performance of the bathroom ceiling, it is also helpful for the leakage of the entire bathroom.

Fifth, the underground water pipe leaks

This kind of water leakage situation is often caused by first throwing off the bricks on the ground, finding the joints of the water pipes, and treating the seals of the joints. If the problem is in the water pipe itself, the water pipe must be replaced. After the replacement, it is necessary to re-buried the water pipe and repair the waterproof layer and the floor tile in the maintenance area.